页数:34页文件大小:382.0 KB来源: 弹性力学ppt课件
本课件围绕简支梁受均布荷载与楔形体展开,用半逆解法求简支梁受均布荷载时的应力分量并与材料力学结果对比,再求解楔形体在自重与液体压力作用下的应力。页面按板书顺序逐页呈现推导过程与结论,方便对照教材复习、自查解题步骤与公式来源。
第三章平面问题的直角坐标解答3—1逆解法与半逆解法3—2矩形梁的纯弯曲3—3位移分量的求出3—4简支梁受均布荷载3—5楔形体受重力和液体压力Solution of Plane Problems in Rectangular Coordinates Inverse Method and Method Pure Bending of a Rectangular Beam Determination of Displacments Bending of a Simple Beam Under Uniform Loads Triangular Gravity Wall
3—4简支梁受均布荷载作用例2.图示矩形截面简支梁,梁高为h,长为2,受均布荷载作用,取板厚度为1,两端的支反力为q,体力不记,求应力函数φ及应力分量(P41)。xh1 yh/2 h/2 oqqq Simple beam under uniform load Consider a simple beam, with length 2 land depthh, subjected toa uniformly distributed load of intensityq. for convenience, only aunit width of the beam is considered, so the reaction at each endwill beql.
1、求应力分量(用半逆解法)由材料力学已知:弯曲应力σx主要由弯矩引起,剪应力τxy由剪力引起,挤压应力σy由荷载q引起。由于q不随x而变化,所以σy不随x而变,可以假设:σy=f(y)而Just as the bending stressσxand the shearing stressτxyare mainlyproduced by the moment and the shearing force respectively, thecrushing stressσyis mainly produced by the direct load on thebeam.Since the direct loadqdoes not vary withx, we may assumethatσyd not vary withxeither and consequently it is only afunction ofy:
f1(y)、f2(y)是待定函数wheref1(y) andf2(y) are arbitrary functions.考察φ是否满足相容方程?To determine the functionf(y),f1(y) andf2(y), we substitutethe expression forφinto compatibility equation, obtaining
代入相容方程得(1)(2)这是关于x的二次方程,要使此方程在x为任何值时恒满足,则此方程中x前的系数和自由项必须为零,即This is a quadratic equation ofx, but it must be satisfied for allvalues ofxbetween–, as the condition of compatibilityrequires. This is possible only when the coefficients ofx2,as well as the term independent ofx, are zero:
(3)由(2)得:略去常数项由(1)得:Integration of (1)and (2) yields:
由(3)得:略去一次式和常数项Substitutingfinto (3) and integrating,we have:The constant term and the term linear in y are neglect,because they will not affect the stress.
The stress components will be:
These expressions satisfy the differentialequations of equilibrium and thecompatibility equation. , if thearbitrary constants A, B,≈, K can bechosen to satisfy all the boundaryconditions, these expressions will be theright solution of the problem.上述应力分量满足平衡微分方程和相容方程,根据边界条件确定积分常述数,即可得正确的解答
σx、σy关于yz面正对称(是x的偶函数)τxy关于yz面反对称,是x的奇函数xyh/2 h/2 oqqq(1)考虑对称性consider the conditionsof symmetry Since theyzplane is a plane of symmetry of the beam and theloading, the stress distribution must be symmetric withrespect to the plane.Thus, the expressions forσx、σymust be evenfunction ofx, while that forτxymust be odd functionofx.
This requires于是得到:E=0 F=0 G=0
xyh/2 h/2 oqqq将应力表达式代入边界条件(2)考虑边界条件consider boundary conditions Substituting the stress components expressionsinto these equations and noticing that E=F=G=0,we have
根据次要边界(左右两面,占很小部分)条件,确定H、K。若不能完全满足,可用圣维南原理Now in order to determine H and K, we can considerthe boundary conditions at the ends of thebeam(the left and right ends of the beam are onlysmall portions of the boundary).If the boundary conditions there cannot be satisfiedexactly, we may apply the Saint - Venant's principleto have the conditions approximately satisfied.
xyh/2 h/2 oqqq边界条件:(1)(2)(3)Boundaryconditions atends:
From (1),we have:K=0 From (2),we have:(3)is satisfied Now the expressions for the stresscomponents are:最后求得简支梁在均布荷载作用下的应力分量为:(3)式恒满足
应力分量沿垂直方向(横截面)的变化规律如图:The stress distribution on a typical crosssection is approximately shown in Fig.:
σx图σy图τxy图σx不是直线规律分布;挤压应力σy发生在梁顶,材料力学中不考虑将上述结果与材料力学中的解答比较Compare the solution obtained here and thatgiven in mechanics of materials,
对板厚为1的矩形截面梁:所以,应力分量的表达式为:For the beam of unit width, we have:So, the stress components ca be rewrittenas:
σx中,第一项为主要项,与材力中的解答相同,第二项为修正项,当h<<时,修正项很小,忽略不计;剪应力的表达式与材料力学中的一样We see that the bending stressσxg in mechanics ofmaterials must be supplemented with a correction term whilethe shearing stressτxy no correction.挤压应力在材料力学中不考虑As to the crushing stressσy, it is only considered in elasticityand not in mechanics of materials at all.
当时,最大正应力应修正1/15当时,最大正应力应修正1/60对的梁,材料力学中的结果足够精确
由于所以梁在左右两边的水平面力为而实际边界上面力的分布情况不清楚,只知道其合力为零,和力矩为零:根据圣维南原理,不管这些面力是否存在,如何分布,在离边界较远处,应力与上述式子是完全一样的
3.5 TRIANGULAR GRAVITY WALLxyρgαγgyExp.
Consider a dam ora retaining wall withtriangular sectionsubjected to theaction of gravity andthe pressure ofimpounded liquid.
Letthe density of thewall material beρandthat of the liquid beγ.
3—5楔形体受重力和液体压力xyρgαγgy图示楔形体,左面铅直,右面与铅直成α角,下端无限长,承受重力和液体压力,楔形体密度为ρ,液体密度为γ,计算应力分量Triangular gravity wall例.
取图示坐标,应力由两部分引起:xyρgαγgy(1)重力:与ρg成正比(2)液压:与γg成正比即,应力可能是ρgx、ρgy、γgx、γgy的组和项At any point in the wall,each ofthe stress components musy consistof two parts:produced by gravity:isproportional toρgproduced by the pressure:isproportional toγgHence, if the stress components can be expressions in the form ofpolynomials, they must be combinations of the expressions in theforms ofAρgx, Bρgy,Cγgx, Dγgy.
可假设应力函数是x、y的纯三次式,即X=0 Y=ρgWe may assume the stress functionφis a polynomialof third degree
These expressions have already satisfied thedifferential equations of equilibrium and thecompatibility equation.It remains to inspect whetherthe boundary conditions canalso be satisfied by propervalues of the arbitraryconstantsa,b,c,d.xyρgαγgyBoundaryconditions:(1)the verticalsurfacex=0
xyρgαγgyα(2)on the inclined surface:
With these values of a, b, c and d, thestress components became:
The distribution of stress components alonga horizontal section of the wall is shown infollowing Fig.:xyρgαγgy---σxσyτxy应力分量σx沿水平方向无变化这个结果在材料力学中得不出来
应力分量σy沿水平按直线规律变化在左面:在斜面:与材料力学中偏心受压公式一样应力分量τxy沿水平按直线规律变化在左面:在斜面:上述解答就是三角形重力坝中应力的基本解答
本章小结(1)按应力求解平面问题得方法有逆解法半逆解法(2)几种简单的平面问题的多项式解答:a、一次式φ=ax+by+c对应无体力、无面力、无应力的情况b、二次式φ=ax2解决矩形板在y方向受均布拉或均布压的问题c、二次式φ=解决矩形板受均布剪力的问题
c、三次式φ=ay3解决图示矩形板纯弯曲问题xy当φ取为坐标x、y的三次或三次以上的多项式时,应力分量将不是常量,而是坐标的的函数,此时,对于同一弹性体,在不同的坐标下,对应的应力分量不同,所解决的问题也不同
(3)求解弹性力学的一般思路或步骤a、确定应力函数(满足双调和方程)b、利用应力函数与应力分量之间的关系求应力分量(满足平衡微分方程、相容方程和边界条件)c、应用物理方程求应变分量d、应用几何方程求位移分量
无法显示该图片。谢谢!作业:P52 3.7.3 P523.7.4
下载地址:{{downurl}}
{{{a}}}
{{#b}}{{{b}}}
{{/b}} {{/title}} {{#nolog}}登陆注册
{{/nolog}} {{#djsx}}点我刷新
{{/djsx}} {{#gocz}} {{/gocz}} {{#ffqr}} {{/ffqr}}